Wand Valve Malfunction

[lesterj2]

Today I was doing a job and five minutes later my wand stopped spraying water..
I think that the handle is not made of a strong enough material. And not pushing the pin in...

 

[Shane T]

You may also want to check the inline filter. Confirm that it is not plugged and also that it is not faulty. Last year I had one that would for some unknown(to me) reason stop flowing. I thought it was the valve but after replacing the valve I still had the same problem so I replaced the inline and problem solved.

 

[lancehollister]

I dought a glogged filtered caused it to stop spraying all at once. I would guess its in the valve or the trigger malfunctioning.

 

[bob vawter]

Yesterday my guy "dropped" the GreenHorn and broke the nipple at the wand valve off......had ta walk next door to the hardware and buy an EZ out...fixed it in about 5 min......

sorry i didn't MEAN to say EZ....my bad!

 

[hogjowl]

WTF does that have to do with Lester's topic, Bawb?

You senile old fart!

 

[bob vawter]

WTF does that have to do with Lester's topic, Bawb?

You senile old fart!

don MAKE me turn on you..
i have "friends" here!

 

[Shawn Forsythe]

WTF does that have to do with Lester's topic, Bawb?

You senile old fart!

Come on Marty, ...

Since when are Bawb's posts on-topic? 'cept for the Rubber Room.

 

[bob vawter]

Were we NOT talking about a wand valve here or WHAT.......

Tre was RIGHT....you all ARE "the haters"..............

 

[Shawn Forsythe]

Nobody hates you, Bawb. You are like the favorite uncle that we yell at when you pass gas.

 

[bob vawter]

don quit yor day job Shawn!

 

[XTREME1]

favorite uncle that you won't let your kids sit on his lap

 

[Dolly Llama]

Today I was doing a job and five minutes later my wand stopped spraying water..
I think that the handle is not made of a strong enough material. And not pushing the pin in...

post a pic Lesder

someone will have a replacement handle if that's what's needed.

It's easy enough to look and see if it's depressing the plunger/pin or not

if it's a "K" valve, you can buy a whole brand new valve on e-bay for $12-$14 bukz

..L.T.A.

 

[Guest]

uncle buck

 

[KevinL]

My nearly new stair tool from Magic Wand quit the other day. I was ready to buy a new valve when I decided to test the QD. I took it off and blew through the valve. It was the qd that was stuck. Put on a new one in 2 minutes and back in biz.

 

[Zee]

Today I was doing a job and five minutes later my wand stopped spraying water..
I think that the handle is not made of a strong enough material. And not pushing the pin in...

Possible overheating causing the water pressure going way up and your wand valve cannot handle the high pressure. Just a thought.
It had happened to me before, back when I was using the "industry standard" 2 jet 1.5" wand.

Or whatever the other guys are saying....

Zee

 

[lesterj2]

ok got the van back from the shop today.. come to find out it was the check valves and packing..