sooooo I am not getting hardly any pressure at the wand...
I have already checked all the lines....i put a lance at the end and it sprayed hard.....spinner...ehhh not so much
I dont use it a ton, but it has been fine for a while.....one job it worked fine, and then i let go of the trigger and it acted up, at the end of the job???
Realized it was the couplings then (had heater debris in them)
so i used it a few weeks ago, fine nothing wrong...
went to use it today...bleh...barely pissed through the job.....
soooooo no hose or machine issues
so where do i start on the tool???
I have already checked all the lines....i put a lance at the end and it sprayed hard.....spinner...ehhh not so much
I dont use it a ton, but it has been fine for a while.....one job it worked fine, and then i let go of the trigger and it acted up, at the end of the job???
Realized it was the couplings then (had heater debris in them)
so i used it a few weeks ago, fine nothing wrong...
went to use it today...bleh...barely pissed through the job.....
soooooo no hose or machine issues
so where do i start on the tool???