Wade Moore
Member
Hi, I could use some help. My last step chemical injection quit working. I have a ss370.
I’ve tighten all clamps to hoses.
What else?
I’ve tighten all clamps to hoses.
What else?
Fred's advice above is exactly where I would start. My Boxxer had a hairline crack in the meter and it would not work. even after I tried to silicone it. Does it prime when you plug your vac hose?Hi, I could use some help. My last step chemical injection quit working. I have a ss370.
I’ve tighten all clamps to hoses.
What else?
It tries to prime. Just keep’s bubblingFred's advice above is exactly where I would start. My Boxxer had a hairline crack in the meter and it would not work. even after I tried to silicone it. Does it prime when you plug your vac hose?
It's sucking air.It tries to prime. Just keep’s bubbling
Where do you think it could be?It's sucking air.
You have to look for it. Could be the tubing or like others said could be a fitting or the meter itself. Over tightening is often an issue with brass fittings. They Crack from the vibration over time. Replace the cheaper parts first if you're not sure where to start and eventually you will find the problem. The parts you replace probably need replacing even if they are not the issue at the moment.Where do you think it could be?
Probably getting air before the pump then.My pump is pulsating a little now as well. Pressure gauge needle moving a little.
Did you check all the o-rings on the valve too?I checked the spring in check valve and it’s ok.
Lol why would this happen. The machine is off
Yes they look goodDid you check all the o-rings on the valve too?
I took the check valves on chem pump and inspected them and they looked good. Should I remove the whole chemical pump? Could it be something there?Yes they look good
Lol I want a aerotecTime to trade it in for a TOPS machine.
join the plumber's union first.Lol I want a aerotec